5mm Glass Shower Enclosures

The tray was disappointing as when levelled on two straight sides (wall) the curved was 8mm lower so the enclosure above had a much larger sealant infill which looks unsightly.Maybe I was unlucky in that the mould and one I got was warped but I?d be cautious as many may have such defects.The tray does scratch easily because whilst taking the film off to do sealant and then fixing shower bits it did scratch whilst hoovering brick dust up so not very tough as described.You need a good or new screwdriver to install the small 8mm long screws because they are installed with a tiny plastic cup washer which you can?t hold or guide while you fix which means they keep dropping out of position and be warned, there are no spares so do be careful as they are testing and hard work.The components are good fit and combine with precision. You do need to proceed carefully as there?s many intricacies of what?s inside or outside and up or down that may cause wasted time as the guide doesn?t always show it clearly.The guide is ok and shows it all in steps but you do need to be a fair hand at diy and particularly hard are the self tapping grub screws which need pressure and strengthening to get home correctlyMy pack was short of essential washers which you could see was a mistake as the pack has numbers on it and it was too few. These washers are quite unique as they allow cover caps over the top to hide screws.4 star build as tray not good and little unfinished with lots of screw head caps showing

Great shower door for my ensuite very pleased

The shower enclosure is solid, looks really nice and the door opens and closes really nicely. The main problem is the instructions are insufficient. I had a professional bathroom fitter and they were unclear on where silicone sealant needed applying. I get water leaking in odd places like at the bottom of end of the screen that the door slides alongside, water runs down the gasket, reaches the frame then pools and overflows out over the frame. Is that poor fitting or a design flaw? It's hard to tell how it's supposed to behave, as there's not enough detail in the fitting instructions.